Intake boot manifold 1600cc
code:2110
OEM:113 129 729B
model:
Type1 1600cc
For dual port intake Type1 engine
Sold per piece
Available update sync 12/08/2022
OEM:113 129 729B
model:
Type1 1600cc
For dual port intake Type1 engine
Sold per piece
Available update sync 12/08/2022
These rubber seals are located on the left and right side of the intake
manifold and take care of the airtight connection between the manifold and the
intake elbows of all twin port Type1 engines.
If due to age or any other reason these seals get torn, this will cause false air and the engine will get a poorer mixture and will run worse. So it is very important that these are in good order.
After long testing, we have found the perfect rubber composition and are made of High Nitrile Rubber Compound and are E10 petrol and heat resistant. Even after one week of full immersion in E10 petrol, these came out untouched, while other samples became soft or dissolved.
Sold individually, 2 are needed on 1 engine. The clamps to fix them are available under BBT 2113.
If due to age or any other reason these seals get torn, this will cause false air and the engine will get a poorer mixture and will run worse. So it is very important that these are in good order.
After long testing, we have found the perfect rubber composition and are made of High Nitrile Rubber Compound and are E10 petrol and heat resistant. Even after one week of full immersion in E10 petrol, these came out untouched, while other samples became soft or dissolved.
Sold individually, 2 are needed on 1 engine. The clamps to fix them are available under BBT 2113.
