This transmount can be found at both sides at the back of the gear box and makes that the gear box and engine are duly kept assembled on the body. The seal can get damaged due to dehydration and the influences of leaking oil so that a good connection without vibrations between the driving part and the body is no longer secured. The hardness of our 1481-100 is measured by Shore A. In this specific item the hardness is 75 til 81 Shore A. this is the classification of the rubber of this item. See illustrations for further explanation.We make our transmission mounts to original VW specs. Volkswagen improved the hardness from the VW beetle one to use these in the VW buses. Back in the day when Beetles didn’t had sufficient horsepower.Today we advice this transmission mount for your VW bus (if applicable) and for your VW Beetle dual port engine or anything 45hp and up… Sold each, two needed per car.For lower HP, 25 and 30 hp engines we advice our Transmission mount BBT 1481
Our products are intended for use only in accordance with the specified instructions. Installation should only be carried out by qualified personnel. Products may be supplied without installation instructions.